|
RMX SPECIFICATIONS
|
|
|
|
|
|
|
||||
| 8 ohms EIA 1 kHz, 0.1% THD |
|
|
|
|
| 4 ohms EIA 1 kHz, 0.1% THD |
|
|
|
|
| 2 ohms EIA 1 kHz, 1% THD |
|
|
|
|
|
|
||||
| 8 ohms EIA 1 kHz, 0.1% THD |
|
|
|
|
| 4 ohms EIA 1 kHz, 1% THD |
|
|
|
|
| Signal to Noise, 20 Hz-20 kHz |
|
|
|
|
| Distortion (SMPTE-IM) |
|
|
|
|
| Input Sensitivity @ 8 ohms |
|
|
|
|
| Voltage Gain |
|
|
|
|
| Output Circuitry |
|
|
|
|
| Power Requirements 1/8 power pink noise at 4 ohms * |
5 A |
6 A |
6 A |
7 A |
| Weight |
|
|
|
|
|
|
||||
| Distortion (Typical) 20 Hz-20 kHz: 10 dB below rated power 1.0 kHz and below: full rated power |
Less than 0.03% THD 4 and 8 ohms Less than 0.03% THD 4 and 8 ohms |
|||
| Frequency Response | 20 Hz-20 kHz, +/- 1 dB, -3 dB points: 5 Hz-50 kHz | |||
| Damping Factor, 1 kHz and below | Greater than 300 at 8 ohms | |||
| Input Impedance | 10 k ohms unbalanced, 20 k ohms balanced | |||
| Input Clipping | 10 Vrms (+22 dB) | |||
| Cooling | Continuously variable-speed fan, rear-to-front air flow | |||
| Connectors, each channel | Input: Active balanced; barrier strip, XLR and 1/4" (6.3mm) TRS tip and XLR pin 2 positive Output: touch-proof binding posts and Neutrik Speakon |
|||
| Controls | Front: AC switch, Ch. 1 and Ch. 2 gain knobs Rear: 10-position DIP switch |
|||
| Indicators | Power-On: Green LED | Signal: Yellow LED (1 per channel) Clip: Red LED (1 per channel) |
||
| Amplifier Protection | Stable into reactive or mismatched loads | |||
| Load Protection | On/off muting, AC coupling (850, 1450), triac crowbar (1850HD, 2450, on each channel) |
|||
| Dimensions | 19" (48.3 cm) rack mounting, 3.5" (8.9 cm) tall (2 rack spaces), 15.9" (40 cm) deep (rack mounting to rear support ears) |
|||
| Power Requirements | 100, 120, 230 VAC, 50-60 Hz | |||
| * @ 120VAC, both channels driven; multiply current by .5 for 230V units |
||||
| All Specification Subject to Change Without Notice. | ||||